Feed

Putting my hand in front of the ultrasonic tape measure I just built. 11cm in front of it, to be exact. #MakersGonnaMake #Arduino #Electronics https://t.co/P9Ms82Xn6S

My cheap Chinese ultrasonic distance sensors have arrived! Which means I could conceivably finish my smart garage build this weekend if it's not too cold out there. #MakersGonnaMake #Electronics #Arduino https://t.co/tRPOgEPCIt

I need to shorten the cables going to the terminal block where the external sensors will connect, but it all fits beautifully in the enclosure. I even added ribbon so I can easily remove it (thanks @asiancwgrl). #MakersGonnaMake #Electronics #Arduino

Alright! Everything's connected. Once I have an enclosure I'll figure out how to organize the components, permanently attach the final three wires and shorten the others. For now, on to software. #MakersGonnaMake #Arduino #Electronics

I am so much better at soldering now than I was when I got up this morning, and I have only one minor burn to show for it. #PracticeMakesPerfect #MakersGonnaMake

Phase II. #MakersGonnaMake #Arduino #Electronics https://t.co/Qyquxli75t

Phase II. #MakersGonnaMake #Arduino #Electronics

So far I've mostly just made a mess of the dining room table. But it's coming along! #MakersGonnaMake #Arduino #Electronics https://t.co/UoD87Ds7re

So far I've mostly just made a mess of the dining room table. But it's coming along! #MakersGonnaMake #Arduino #Electronics

Starting to build the ludicrous design I came up with last weekend. #MakersGonnaMake #Arduino #Electronics https://t.co/IsCWxZ0Mgw

Starting to build the ludicrous design I came up with last weekend. #MakersGonnaMake #Arduino #Electronics